MATERIAL SAFETY DATA SHEET

Complement Technolongy, Inc.

Product: C3d, Human

4801 Troup Hwy, Suite 701

Phone: 1-903-581-8284

Catalog # A117

Tyler, TX 75703, USA

Fax: 1-903-581-0491

Effective date: 7/1/2010

Email: contactcti@aol.com

Website: www.ComplementTech.com

SECTION I – PRODUCT IDENTIFICATION

Product Name:

C3d, Human

Molecular Weight:

32,000

CAS #:

N/A

NIOSH/RTECS #:

N/A

Product Use:

For Research Use Only. Not for Human or Drug Use

SECTION II – PHYSICAL DATA

Appearance and Odor:

Frozen liquid at -1^oC or below. Clear, colorless liquid at 0^oC or

above. No odor.

SECTION III – HEALTH HAZARD

Toxic:

No toxicity data is available

Threshold Limit Value:

Not Established

Short Term Exposure Limit:

Not Established

Permissible Exposure Limit:

Not Established

Carcinogenicity:

None Identified

Reproductive Effect:

None Identified

Effects of Overexposure:

Inhalation:

None Identified

Skin Contact:

None Identified

Eye Contact:

None Identified

Ingestion:

None Identified

Chronic Effects:

None Identified

Target Organ:

None Identified

Primary Route of Entry:

None Identified

First Aid Procedures:

Ingestion:

If swallowed, wash mouth with water provided person is

conscious. Call a physician.

Inhalation:

Move person to fresh air. If breathing becomes difficult, call a

physician.

Skin Contact:

Flush skin area with plenty of soap and water for at least 15

minutes.

Eye Contact:

Flush with plenty of water for at least 15 minutes.

SECTION IV – REACTIVITY DATA

Stability:

Stable

Hazardous Polymerization:

Will not occur

Hazardous Decomposition:

Unknown

Conditions to avoid:

None documented

Incompatibility:

None documented

SECTION V – SPILL, LEAK AND DISPOSAL PROCEDURES

Spill:

Wear suitable protective clothing including safety goggles and

gloves. Carefully wash spill site area to completely remove

spilled material. Chemically disinfect the area of spill or leak site

completely.

Disposal:

Disposal of spilled or unused material should be made in

accordance with existing disposal practices employed for

infectious waste at your institution. Observe all federal, state,

and local environmental regulations.

SECTION VI – STORAGE & HANDLING PRECAUTIONS

Ventilation:

Use adequate general or local exhaust ventilation.

Respiratory Ventilation:

None required where adequate ventilation conditions exist.

Eye/Skin Protection:

Safety goggles and proper gloves are recommended.

Human source material from which this product was derived was found to be negative for

Hepatitis B surface antigen and negative for antibodies to HIV and Hepatitis C virus (HCV) by

approved test methods. Since no test method can offer complete assurance that Hepatitis B,

Hepatitis C, HIV, or other infectious agents are absent, this product should be handled using the

same safety precautions employed when handling potentially infectious materials. Label

this product as a potential biohazard capable of transmitting infectious agents.

SECTION VII – FIRE & EXPLOSIVE HAZARD DATA

Flash Point:

N/A

Auto-ignition Temperature:

N/A

Flammable Limits:

N/A

Fire Extinguishing Media:

Use extinguishing media appropriate for surrounding fire.

Special Fire-Fighting Procedures:

Wear self-contained breathing apparatus and protective clothing.

Unusual Fire & Explosion Procedures:

None identified

Toxic Gases Produced:

None identified

The information given above is believed to be correct but is not necessarily all inclusive and

should be used only as a guide. Complement Technology, Inc. shall not be held liable for any

damage resulting from the handling or from contact with this product.